10. OUTPUT Section
The output section represents the internal routing matrix and state of the outputs. Routing is performed
by selecting an output and assigning any input to it. When a routing is active, its input is automatically
monitored for lock and sync in the input section. For AVB stream outputs, their states are additionally
monitored in the output section.
Example:
In the
OUTPUT
section,
MADI Optical 1-12
is chosen as source for
AVB Stream 2
. The 12Mic is clock
master, but the incoming MADI signal is not correctly synchronized. This causes a warning in the
INPUT
section. If
MADI Optical
is not routed to any output, an invalid or missing signal does not cause a
warning.
Use the web remote to find out quickly which outputs are receiving a specific input signal.
The web remote provides a thorough representation of all active routing connections at a
glance.
Device Output Section
The device allows full inspection and configuration of outgoing signals including routing in four channel
blocks.
10.1. Routing Signals to the Outputs
Each output channel of the 12Mic can receive any input signal. If preset 1 has not been modified, it
contains a routing of all analog inputs to all digital outputs. However, this can be adjusted and changed
easily. The factory default preset does not contain any routing.
A routing immediately activates input monitoring for a corresponding digital input and
raises a warning in the input state if the source signal is not available or out of sync.
The following example shows the procedure to route to MADI Coaxial output channels. Other outputs
follow the same principle.
To create a routing to a MADI Coaxial output on the device:
1. Open the routing tab of the MADI Coaxial output in the
OUTPUT
section (
2. Activate the routing destination and choose an output channel with the encoder (1, 2).
3. Activate the routing source and choose an input channel with the encoder (3, 4).
To remove a routing on the device:
RME 12Mic User’s Guide
49
| 10. OUTPUT Section