
All channels in a gain group will reach the same gain value when the offset reaches its
maximum/minimum value. Any previously created gain differences between the channels
will be lost.
It is possible to adjust the gain of individual channels even when they are part of a gain
group.
In order to create an equal gain for all channels in a group, first set the offset of the group
to its lowest (negative) value. Then, increase the offset to the preferred gain.
9.1.8. Creating a Gain Group
Gains can be linked directly at the device using the following methods.
To link the gain of two or more consecutive input channels while the device is idle (main screen):
1. Press and hold the first button at the first input. The channel is selected as the first channel in a
group.
2. While holding down the first button, press a second button at another input. All inputs in-between will
be added to the group. Release the buttons and adjust gain as required.
Channels that participate in the current group are shown with colored level meters and
a connecting line towards the encoder. Channels that do not participate in the group
have grey level meters.
3. Hold down the third button (
+
) to add or remove individual channels from the group.
To link the gain of a selected channel to additional channels:
1. Press and hold the third button "+". The button turns green and an instruction will be shown.
2. Press a second button at another input. The new gain group is shown.
RME 12Mic User’s Guide
9.1. Analog Inputs |
44