38 • Measuring Mode, Normal Operation Gas Tracer Operator’s Manual, CSA Version
NOTE:
If your Gas Tracer is configured to respond to both H
2
S and CO, be sure
to calibrate the CO channel using CO.
Snap Log Mode, Normal Operation
NOTE:
For instructions to take snap log data if using the Gas Tracer in Leak
Check Mode, see “Snap Log Mode, Leak Check Mode Operation” on
page 106.
The snap logging function in Snap Log Mode allows the user to record data at a
specific time and have it saved to the data logger. The data is assigned a snap log
ID and is saved with the station ID that was in use when the data was taken.
To enter Snap Log Mode and record snap log data:
1. Turn the Gas Tracer on as described in “Turning On the Gas Tracer, Normal
Mode Only” on page 25. Press and hold the (SHIFT)
button, then press and
hold the AIR
button and hold both until you hear a beep. The unit will cycle
through the following screens.
