AirLink 9850 Gas Monitor Operator’s Manual
Chapter 5: Setup Mode • 31
5. Manual IP Address Settings: Use
ADD
or
SUB
to manipulate the flashing value. Press
MENU
to
accept the value and move on to the next one.
NOTE:
This item only appears if “Manual” was selected as the IP Address Type. Contact your
network administrator to obtain the proper values. Enter the provided values exactly (without
any leading 0’s).
6. Press
MENU
.
7. The AirLink 9850 returns to the TCP/IP Settings menu screen.
8. Press
ADD
to continue to the Alarm Settings screen or press
RESET/ESC
to return to Normal
Operating Mode.
Alarm Settings (and Channel On/Off)
NOTE:
Alarms are only indicated on the website and on the Modbus output. There are no local
alarms at the AirLink 9850.
1. If necessary, press and hold
MENU
for 6 seconds to enter Setup Mode and then press
ADD
until
the Alarm Settings menu screen appears.
2. Press and release
MENU
to enter the Alarm Settings menu.
3. Address: Use
ADD
or
SUB
to display the AirLink sensor assembly radio address (1-255) that
you’d like to set alarms for.
4. Press
MENU
.
