Steelhead Appliance Installation and Configuration Guide
45
Bypass Card Status Lights
Overview of the Steelhead Appliance
To validate a Two-Port Copper Gigabit-Ethernet Bypass Card (150-00004)
For the Two-Port Copper Gigabit-Ethernet Bypass card (150-00004), the links are indicated by the following
status lights:
Flashing green LEDs on the ports.
Heartbeat LED to the right of ports is lit and flashing amber.
Intercept/Bypass LED is solid.
Removing the cable when the card has a link causes the green LEDs on the ports to stop flashing.
Two-Port Copper Gigabit-Ethernet Bypass Card-B
The following section describes the Two-Port Copper Gigabit-Ethernet Bypass (Two-Port Copper Gig-E
Bypass) Card-B (150-00002) status lights.
Figure 1-27. Two-Port Copper Gigabit-Ethernet Bypass Card-B
The following table describes the Two-Port Copper Gig-E Bypass Card-B, status lights.
The following table describes the Two-Port Copper Gig-E Bypass Card-B, LED lights.
100 Mbps
(100 Base T)
Link
SOLID OFF
Active
FLASHING OFF
1000 Mbps
(1000 Base T)
Link
FLASHING SOLID
Active
FLASHING FLASHING
Status Lights
Signal
Description
Intercept/Bypass
SOLID (GREEN)
Normal State
Heartbeat
OFF
Bypass or Power Off
Status
Left LED
(Solid Green)
Right LED
(Solid Yellow)
Link
ACTIVE
LINK
Network Link Not Established
OFF
OFF
Status
Left LED
Right LED
