Rittal enclosure heater assembly instructions
3
1 Notes on documentation
EN
1
Notes on documentation
These assembly instructions are aimed at
– tradespersons who are familiar with
assembly and installation of the heater
– trained specialists who are familiar with
operation of the heater
1.1 Other applicable documents
Assembly and operating instructions exist
as paper documents for the unit types
described here and are enclosed with the
equipment.
We cannot accept any liability for damage
associated with failure to observe these in-
structions. Where applicable, the instructions
for any accessories used also apply.
1.2 CE certification
The declaration of conformity is supplied with
the unit as a separate document.
1.3 Retention of documents
These instructions and all associated
documents constitute an integral part of the
product. They must be given to the plant
operator. The operator is responsible for
storage of the documents so they are readily
available when needed.
1.4 Symbols used
2
Safety notes
– When performing the electrical installation,
it is important to observe all valid national
and regional regulations as well as the
provisions of the responsible electrical
supply company.
– Electrical installation must only be carried
out by a qualified electrician who is
responsible for compliance with the
existing standards and regulations.
– Use only original spare parts!
– The heater must not be touched while
switched on. Risk of burns from hot
surfaces! The heater must be allowed to
cool for approx. 15 minutes after switching
off.
The bullet point indicates an
action to be performed.
Danger!
Immediate danger to life and
limb!
Caution!
Potential threat to the product
and its environment.
Note:
Useful information and special
features.
䡲
Caution!
Risk of burns from hot surfaces!
