5
The performance of any machine can be no better than
the installation. The WHEEL-LOK
™
restraint requires
only normal application and installation skills.
WHEEL-LOK
™
restraints may be installed at dock
locations equipped with RITE-HITE
®
or other levelers.
Levelers can be either recessed in pits or mounted on
the top edge of the dock. A WHEEL-LOK
™
restraint can
be installed at docks without any leveler.
Take the time to review this manual and to become
familiar with all of the parts and assemblies of the
WHEEL-LOK
™
restraint before beginning installation
procedures.
WHEEL-LOK
™
POWER SOURCE
On occasion, the incoming electrical power for the
WHEEL-LOK
™
restraint is taken from a convenient
nearby electrical power source. Generally there is no
problem following this procedure; however, make sure
that the conductors supplying power to the
WHEEL-LOK
™
restraint control box have a capacity of
20/10 amps at 240/480 volts. The power source voltage
must be specified when ordering WHEEL-LOK
™
.
If any questions or problems arise, contact your
RITE-HITE
®
representative or the RITE-HITE
Corporation at 414-355-2600.
8-1/4"
WHEEL-LOK
TM
In Full Forward Position
(Shown In Phantom)
WHEEL-LOK
TM
In Stored Position
163" Travel
7-3/4"
94"
Overall Length Of Track Can Flex
Max. 4" Up Or Down (1/2" Per Foot)
Loading Dock
Face
Loading Dock
Face
250"
10"
5"
C
L
11"
Bumper Face
Motor Box
Sled
Track
Do Not Shim Beyond
Mounting Pad Closest To Building
5-1/2"
INSTALLATION AND APPLICATION
INSTRUCTIONS
TYPICAL VIEW INSTALLED WHEEL-LOK™
