Rite‑Hite
®
Installation/Service/Owner's Manual
Eclipse
®
Dock Shelter (620G, 620NH)
Publication:
AMEN00141 2019-11-22
9
INSTALLATION
Canopy Header
Continued
Endcap
Endcap
5 Unroll and then lift and lay the canopy cover (top bar
attached) on top of the side arms at the wall
Lift up and slowly position the top bar behind the tabs
on the canopy mounting brackets
Make sure the top bar is oriented correctly
• All 4 faces of top bar should be covered with fabric
• Fabric should be wrapped from front face of top bar,
under the bottom, up the back (against the wall),
across the top towards the front of the unit, then
extend from the top, front corner of the top bar down
to the front bar
• The canopy cover and end caps (at the corners
where the canopy top and end cap meet) are laying
correctly over the edge of the mounting bracket
6 Drape canopy cover over the front bar (the
2 1/2in [65mm] square tubing) Make sure the canopy
cover at the front corners lays correctly over the
corners of the front bar
Side View
Part of End Cap
Removed for Clarity
Pocket with Poly
Notch
7 Wrap the canopy cover front bar pocket (with poly strip
inside), down and around the bottom of the front bar
• The pocket/poly strip will wrap back up the back
inside face of the front bar and tuck behind the steel
angle welded at back
•
The pocket is notched to fit around the side arm
bracket and the edge of the pocket should line up
with the edge of the steel angle on both ends about
1/2in [13mm] away from the side arm bracket Make
sure that the pocket/poly strip combination gets
seated all the way down in the space between angle
and front bar
Figure 9
Figure 10
