12 - 13
CZ180 / CV1860 Rev. 1.0
CHAPTER 12: MASTER MAKING SECTION
10. Master stocker roller (bottom)
1) Remove the Drum from the machine, turn OFF the machine power and remove the Front cover
from the machine. (M3x8 screws; 6 pcs)
2) Remove the Master removal upper cover. (M3x8; 2 pcs)
3) Remove the Master scanning upper frame cover. (M3x8 screws: 4 pcs)
4) Remove the Scanner unit cover. (M3x8 screws; 4 pcs)
5) Remove the Housing stay-A. (M3x6 screws; 2 pcs)
6) Open the Master making upper unit. By removing the Housing stay-A in the previous step, the
unit will open wider.
7) Remove following parts.
Master positioning sensor bracket (M3x6 screw; 1 pc)
Unplug the wire harness connector of the Master end sensor.
Cutter guide assembly (M3x6 screws; 2 pcs)
Write pulse motor assembly (M3x6 screws; 2 pcs)
8) Remove the Pulley assembly and E-ring on the back. (4mm dia. E-ring)
9) Remove the E-ring under the Master stocker roller (bottom), and slide the roller to the front and
remove the roller. (4mm dia. E-ring; 2 pcs)
Master stocker roller (bottom)
Pulley assembly
Master stocker roller (bottom)
RISO Inc. Technical Services & Support
US.RISO.COM
