Rioned flexJET, User Manual

Page: 62 / 78

01/18 58
Hydraulic reel does not wind the
hose Handle not on right position Put the handle into the right position
Hydraulic tank almost empty Refill the tank. Check the system on
leakage
Drive chain not sufficiently tighten Tighten the chain
Attachment bolt for control lever of
hydraulic system loosened fasten the bolt and put the lever into
the correct position
Working pressure set too low Increase the working pressure, if pos-
sible
Return filter hydraulic tank dirty Switch off the machine and clean the
return filter
Hydraulic system damaged Contact your dealer
No reaction by switching in
transmitter No current Load battery
Use new battery
Control contact points on dirt and dust
Check fuses
Contact your supplier by repeating dis-
turbances
Transmitter is not on Put button 0/1 to position I
Transmitter out of reach from receiver Put the machines closer on. Put trans-
mitter closer
Warning signal after short
working time Battery empty / defect Load or replace
Battery not loaded or defect Charge battery complete
Check if the plug is connected and if
the contact is on.
Check if the charging works well
Check battery points / clean it
Use other battery
Transmitter indications are good
but functions are not executed Emergency stop pushed in Unlock emergency stop
Receiver has no current Check / replace fuses
No radio connection Check functions of control lights
Certain functions are not exe-
cuted Receiver is faulty Contact your supplier
Interruption in electric circuit Check all plugs. Plug in and push.
Check control lights if functions are
indicated
Insufficient braking effect Excessive backlash in brake system Re-adjust brake system by Rioned
Brake linings not “run in” Actuate hand-brake lever slightly;
drive 2-3 kilo meters
Brake linings glazed, oily or damaged Replace brake shoes completely; clean
braking areas in the brake drums
Overrunning hitch hard to operate Grease overrunning hitch
Brake linkage is jammed or deformed Eliminate cause
Brake cables rusted or kinked Replace cables
Failure Reason Solution