Rinstrum C500 series, Reference Manual

Page: 65 / 182

13 Alibi Application
13.1 Introduction
The Alibi application is part of the trade approval and makes it possible to verify scale readings, view DSD
and change log entries. It can be accessed from the main application by a long press of the Select key, and
then selecting Alibi from the list.
On starting, it displays the following information:
ˆ
“Alibi” to identify that the Alibi application is running
ˆ
ADC library version (this is listed on the trade approval)
ˆ
ADC library checksum (this is listed on the trade approval)
ˆ
Current calibration counter value
13.2 Changing Modes
In all Alibi modes, a long press of the F2 key will access the mode menu. Pressing the up or down keys will
advance through each mode, and the F2 key will enter that mode. The “-END-” entry will exit Alibi mode
and return to the main application.
13.3 Weighing and Counting Modes
The following keys apply in Alibi Weighing and Counting modes:
Short Press Zero Zero the scale.
Long press (none)
Short Press Tare Tare the scale
Long press Preset Tare Enter a preset tare
Short Press Select Toggle between gross and net weight.
Long press Alibi Mode
ƒ
1
Short Press Print Print a simple traceable printout:
00000039 2012\06\16 07:04:08
50.0 kg G
50.0 kg N
0.0 kg T
Long Press (none)
ƒ
2
Short Press (None)
Long press Mode menu Long press to access the Alibi mode menu
ƒ
3
Short Press Enter Pieces Enter pieces (only in counting mode)
Long press (None) Cancel pieces display and return to weight display (only in
counting mode)
60 C500-600-2.0.3