Rinnai Australia
43
Sapphire Operation & Installation Manual
COMPLETING HEATER INSTALLATION
Step 3.
Installing the Log Set and Burner Granules
For clarity the drawings are displayed without showing the entire heater.
DO NOT remove the burner from heater engine to install the log set.
Use extreme care when handling the Log Set components, they are made from a very fragile high
temperature material and will damage if handled roughly. Only remove the components from
their packaging as required.
Check to ensure that the ports of the main burner
are clean and clear of any particles and all packaging
material. The log set
MUST BE
installed in the precise
order as stated.
Log
. Select the thicker 'Y' shaped log and fit into
position by lining up two pin holes onto the two pins of
the locating bracket that is fixed to the centre of the
main burner.
Log
. Select the thick straight log and fit onto the
sheet metal locators at base of the left side and rear
panels. When correctly located this log will be touching
the burner box walls.
Log
. Select the thinner 'Y' shaped log and fit into
position by lining up two pin holes onto the two pins of
the first two logs. Ensure this log is seated all the way
down until it touches logs
and
.
Log
. Select the longest log and fit onto the sheet
metal locators at base of the right side and rear panels.
When correctly located this log will be touching the
burner box walls and be lightly resting on log
.
Log
. Locate the final bowed log onto the sheet
metal locator at the base of the right side panel and the
bracket fixed to the main burner, lean the log back until
it rests on piece number
.
NOTE
1
1
2
1
3
1
2
2
3
1
2
4
1
5
4
4
1
5
4
