Rinnai EHP-WH110, User'S And Installer'S Manual

Page: 44 / 48

44
6.1 TECHNICAL CHARACTERISTICS
TECHNICAL DATA SHIMANTO 110
Power supply V/Ph/Hz 220-240/1/50
Water tank real capacity L 110
Heating capacity W 850* (+1500**)
Rated power input W 236* (+1500**)
Nominal current A 1,14* (+6,5**)
SCOP
DHW
(ERP) *** W/W 3,01
Max power input W 400 (+1500**)
Max current A 1,81 (+6,5**)
Heating time with cold tank (***) h:min 6:53
Stand-by power input (***) W 13,4
Max. outlet water temperature
(without E-heater operation)
°C 60
Max water temperature ** °C 70**
Minimum temperature for starting °C 10
Working ambient temperature °C -5 ~ +43
Refrigerant max. discharge pressure bar 25
Refrigerant max. suction pressure bar 0,2
Refrigerant type R134a
Refrigerant GWP 1430
Refrigerant charge g 650
Amount fluorinated greenhouse gases tCO
2
eq 0,93
Compressor
Type Rotary
Oil (type) 68HES-H
Oil (q.ty) 376 ml
Fan motor
Tipo AC
W 20
Nominal air flow m3/h 300
Available static pressure Pa 60
Air flow at 60 Pa m3/h 170
Duct diameter mm DN 125
Max allowed pressure water side bar 8
Relief valve setpoint (to install externally) Bar 6
Material of of the inner surface of the tank S235JR with double-layer vitrification
Auxiliary electric heater kW 1,5
Electronic expansion valve yes
Magnesium anode yes
Material of the heat pump exchanger (condenser) Copper
Chilled water input inch G 1/2 ” male
Hot water outlet inch G 1/2 ” male
Condensed water outlet Flexible plastic tube Ø18 mm
Drainage inch To be installed externally
Power cable length m 1,5
IP protection class IPX1
Net dimensions LxHxW mm 500x520X1406
Packing Dimensions mm 550x550x1460
Net Weight Kg 72,0
Weight with full tank Kg 182
Gross Weight Kg 84,0
Sound power **** dB (A) 48,5
NOTE:
* Heating capacity, power input based on the following conditions:
- ambient temperature 20°C, water temperature from 15°C to 55°C (obtained results by internal laboratory tests
based on the uniform reintegration of the tank temperature).
** In relation to the auxiliary electric heater. During the anti-legionella cycle, the temperature is raised to 70°C by the
electric heater.
*** Obtained with the tank stored at an ambient temperature of 20°C, with air inlet of the duct at 7°C and all other
parameters in accordance with EN 16147.
**** According to EN 12102: ducted unit in/out 2m.