Riken Keiki OX-591, Operating Instructions Manual

Page: 13 / 36

12
４－３．Installation place
Keep away the system from direct sun drought or where the temperature of the system is
drastically changed. If installed, inside the unit will be built up condensation and does not follow
the drastic temperature change.
The system consists of fine electronics parts.
Install them where to be stable not to crush or fall down.
Keep the system from the equipment which may give a high frequency in the surroundings and install
it.
・Do not put the system jointly each.
・Do not wire the cable in parallel nor take access.
.
Do not install and make gas detection at the place where the sample gas is deposited.
This unit is required to make maintenance regularly.
Then, do not install at the place where there is danger at maintenance time.
When required to stop the system at maintenance time, unable to maintain if not remove a part of
system or unable to detach the case due to the pipe or rack etc. do not install such place.
Be sure to ground when installing to the equipment.
Do not install at places where direct sun drought or where the temperature is drastically changed.
Do not install it where vibration or shocks may take place.
Keep the system from the equipment which may generate the noise (Unit & cable).
Do not install it where the detection gas is deposited around.
Do not install at the place where it is danger for maintenance service such as high voltage cable,
etc.
Do not install it where it is unable to make maintenance.
Equipment housing that grounding construction is not enough.
CAUTION