T
I
+44 (0)1926 290 418 E
I
I
www.rigtec.com
3
SAFETY INFORMATION
These instructions should be handed over to the
person carrying out the installation.
•
Only a qualified, trained and competent technician should carry out
installation work.
•
The device should only be used with approved accessories and spares.
•
Do not exceed the Working Load Limit (WWL) –
when used with other
accessories make sure that the Working Load Limit of any component is
not exceeded.
•
Care should be taken when lifting and moving –
the combined weight of
the device and any accessory should be within safe manual handling limits.
•
Care should be taken when transporting that injury is not caused
-
make
sure the device and any attached accessory is correctly secured.
•
All equipment should be visually inspected before use and in the event of
any damage, it must be immediately taken out of service and assessed by a
competent person.
•
Any suspended accessory must be independently secured with an
approved safety wire/s. Local laws or regulations should be consulted
regarding the additional safety of hanging equipment
•
When working at elevated heights or under a suspended load, make sure
that all necessary precautions have been taken.
•
Only install the approved projectors into the Air Frame, as listed in the User
Guide. Attempting to install projectors other than those listed in the User
Guide may result in serious injury.
•
Do not use the Air Frame outdoors. The Air Frame should not be installed
where it can be exposed to wind or rain.
•
Do not expose the Air Frame to moisture or excessive heat.
•
Do not install the Air Frame on unstable surfaces.
•
Do not hang the Air Frame from unstable, unsafe or inappropriate objects/
structures. Ensure the structure can support the overall weight.
•
When stacking Air Frames, ENSURE all four locking pins are securely
positioned through the adjoining male and female Air Frame stacking
connectors.
