RIGOL
RSA3000E User Guide
6-3
Remote Control via USB
1.
Connect the load to the PC
Use a USB cable to connect the analyzer (USB Device) with the PC (USB Host).
2.
Install the USB driver
The analyzer is a USBTMC device. After you connect the analyzer to the PC
properly and power it on for the first time (the analyzer will be automatically
configured with the USB interface). In this case, "Found New Hardware Wizard"
dialog box appears on the PC. Please install "USB Test and Measurement Device
(IVI)" according to the instructions.
3.
Search for the device resource
Start up Ultra Sigma (here we assume that you have installed Ultra Sigma
properly) and the software will automatically search for the resource currently
connected to the PC. You can also click
to search for the resource.
4.
View the device resource
The resources found will appear under the "RIGOL Online Resource" directory,
and the model number and USB interface information of the instrument will also
be displayed.
For example, RSA3030E (USB0::0x1AB1::0xA4A9::L355010000000::INSTR).
5.
Communication test
Right-click the resource name "RSA3030E
(USB0::0x1AB1::0xA4A9::L355010000000::INSTR)" and select "SCPI Panel
Control" to turn on the remote command control panel, through which you can
send commands and read data. For details about the SCPI commands and
programming, refer to
RSA3000E Programming Guide
.
