Rigol PR7080S, User Manual, Page: 43 / 49

RIGOL
RP7000S User’s Guide 13
①
Hand-held single-ended probe head (RP7S-0205).
②
91Ω probe tip (RP7-0405).
③
Straight acuminate ground collar: rotating the ground collar adjusts the
spacing (0mm to 5mm) between the ground collar and probe tip
(RP7-0501).
CAUTION
Ground the ground collar when using the hand-held single-ended
probe.
To Replace Probe Accessories
1.
To replace the probe head
Take care not to damage the connecting part to avoid affecting the probe
performance when replacing the probe head.
Replacing Method:
①
Disconnect the current probe head from the active probe amplifier.
②
Push the new probe head into the active probe amplifier straightly.
When single-ended probe head is used, pay attention to their
polarities.
2.
Replace the probe tip
The
probe tip and probe head are connected with screw thread, so please
note the screw rotation and strength when removing and installing the
probe tip.
3. Replace the single-ended ground collar
Make sure the single-ended ground collar is firmly connected to the
copper pipe to ensure the probe performance when replacing it.