Rigol DSA1030, User Manual

Page: 85 / 287

Front Panel Key Reference RIGOL
User’s Guide for DSA1000 Series 2-31
2.2.5 Single
Sets the sweep mode to Single.
Key Points:

If it is in Continue sweep mode and no measurement function is enabled,
pressing this key will enter the Single sweep mode and execute specified number
of sweeps on the condition that all trigger conditions are satisfied.

If it is in Continue sweep mode and a measurement function is on, pressing this
key will enter the Single measure mode and execute specified number of
measurements on the condition that all trigger conditions are satisfied.

If the system is already in Single sweep mode, pressing this key will execute
specified number of sweeps (or measurements) on the condition that all trigger
conditions are satisfied.

In Single sweep mode, trigger initialization (pressing Single or sending an INIT
command through the remote interface) should be executed before you judge the
trigger condition.
Press Single
Measuring Status?
Single Sweep Status? Single Sweep Status?
Enter Single Sweep mode
and Wait for Trigger
Condition
Enter Single Sweep/
Measure mode and Wait
for Trigger Condition
Sweep Again and Wait
for Trigger Condition
Wait for Trigger Condition
and Make Single
Measurement Again
N
N
N
Y
Y
Y
Figure 2-11 Process of a single sweep