Rigol DG800 Series, User Manual

Page: 111 / 148

Chapter 2 Front Panel Operations RIGOL
DG800 User's Guide 2-81
Channel Setting
The function and setting methods of CH2 are the same as that of CH1. This section
takes CH1 as an example to introduce the channel setting method. To set the CH2
channel output parameters, select CH2 (refer to "To Select Output Channel") and
then set the channel according to the descriptions in this section.
Tap the channel output configuration status bar
or under
the user interface to enter the channel setting interface. Tap the corresponding menu
label to set the parameters related with the channel.
Figure 2-23 Channel Setting Interface
Output Setting
1. Output On/Off
Enable or disable the signal on the [CH1] connector. In the channel setting
interface, tap the OutputSet menu label, and then tap the Output parameter
selection field to select "On" or "Off" to enable or disable the signal output. By
default, it is set to "Off".
2. Output Polarity
Set the signal on the [CH1] connector as Normal or Inverted. Waveform is
inverted relative to the offset voltage. In the channel setting interface, tap the
OutputSet menu label, and then tap the Inverted parameter selection field to
select "On" or "Off". By default, it is set to "Off". If "Off", the instrument outputs
the normal waveform; if "On", the instrument outputs the inverted waveform.
For example, if Inverted is "Off" (normal mode), the first half period of the
waveform in the cycle is Positive; if Inverted is "On", the first half period of the
waveform in the cycle is Negative, as shown in the figure below.