Rigol DG4062, User Manual

Page: 195 / 238

Chapter 10 Utility Functions and System Settings RIGOL
DG4000 User's Guide
10-25
Channel Copy
DG4000 supports state copy or waveform copy function between its two channels,
namely copy the state (parameters and output configuration) or arbitrary
waveform parameters of one channel to the other or swap the states of the two
channels.
Press
Utility

Channel Copy to set the parameters of channel copy. This
setting will not be affected by the preset operation.
1.
Copy Type
Press
Type at the front panel to set the content of channel copy to "Sate" or
"Wform".

State: include waveform (except volatile waveform) and waveform
parameters (such as frequency and amplitude), functions (such as
modulation, sweep and burst) as well as output configurations (such as
sync, resistance and polarity) of the channel.

Wform: arbitrary waveform data (except waveform parameters). Available
only when both of the two channels select arbitrary waveforms.
2. Copy Direction
Press
Direction to set the direction of channel copy as "CH1->CH2",
"CH2->CH1" or "Swap" ("Swap" is only available when the copy type is set to
"State").
Then, pressing
CH1 CH2 at the front panel under any interface can execute the
channel copy operation.
Note: Channel coupling and channel copy are mutually exclusive. Channel copy is
forbidden when channel coupling is enabled.