113
SYSTEM MANAGEMENT
5.3
Setting depending zone parameters
Controls interface
2
1
3
4
5
6 7
9
8
10
1
255x80 point backlit display (106,4x39,0mm)
2
RESET key: restores normal operations after a safety shut-down
3
MENU key: switches on the main menu
4
ESC key: in menu navigation, it enables you to exit a menu item and go back to the previous
one
5 ÷ 9
Navigation keys
◄
,
▼
,
●
,
►
,
▲
10
Main switch (placed on the rear panel of the equipment)
5.4
Setting zone parameters (accessible only with installer password)
Menu
→
“Settings”
→
“"Config. Dep. Zone”
This menu allows you to separately set the parameters of all the connected zones with the exception of the “Extra setpoint zone”
which is the same for all zones.
To select the zone for controlling/changing the parameters, proceed as follows:
− press the
►
key so that the number to the right of “zone” is highlighted;
− once the number is highlighted use the
▲
and
▼
keys to change the number of the zone;
− once the zone is selected, confirm with the
●
key.
The zone parameters are the following:
Description
Standard
value that
is set
Range
Explanation
UM
Post-circ. Zone Pump
120
0-255
Establishes the time in seconds of the
post-circulation
Secs
Extra zone setpoint (*)
10
0-30
Establishes the increase for the primary set-
point with respect to the zone setpoint
°C
9
For more information regarding navigating the commands interface (thermal module display) see the paragraph "Electronic
9
(*) If a direct depending zone is used, set the Extra zone setpoint value to 0
