29
INSTALLER
INSTALLER
3.12
Door hinges
The boilers are equipped with 4 hinge points to allow a rapid
reversal of the door opening direction.
Check that the opening direction foreseen in the factory is the
desired one or modify it according to that indicated in chapter
"Variation of the door opening direction".
3.13
Changing the direction of door opening
The boiler door hinges are fitted on the right of the door in the
factory.
If you need to reverse the direction of opening, remove the boil-
er’s side panel and proceed as follows.
9
Check that the main locking screws (1) are fully tightened.
1
− Remove the snap ring (2) and the through pin (3).
− Unscrew the screws (4) and remove the support/centring
bracket (5).
− Unscrew the nuts (6) and remove the plate (7).
2
3
4
5
4
6
7
Top hinge
− Loosen the bolts (1) and remove the snap ring (2).
− Remove the through bolt (3).
1
3
2
− Unscrew the four nuts (4), remove the bracket (5)and re-
fit it on the opposite side by reversing the sequence of
actions.
5
4
− From this side, fit the support/centring bracket and rela-
tive pin previously removed.
