29
Bolero User Manual A20
2.4.9.1 Antenna OTA
This registration mode allows registering a Beltpack at an already registered Antenna over the air (DECT).
Following steps are necessary to register a Beltpack via Antenna-OTA to a Bolero Net:
·
At first the '
Registration Method (OTA)
' must be activated. This can be done in two ways:
a)
Via the Antennas Web-Interface
(see chapter
'Bolero Antenna > Features in Detail > Registration'
).
b) Via another Beltpack that is already registered in the Net:
Menu '
Admin > Registration Mode > Over The Air > On
'.
·
Then start the registration process in the Beltpack that should be connected to the Net:
a)
If the Beltpack is not registered to any Net, press and hold the '
Reply
' key for one second. The Beltpack starts
automatically searching for available Nets.
b) If the Beltpack is already connected to another Net, push the Beltpack's Menu key for >3 seconds (long key
press), navigate to the menu '
Registration
' and select '
Register to net
'.
The Beltpack begins to search for available Nets and displays them one at a time.
Figure 18: Net searching
·
The Beltpack will continue to search until a Net is found or '
Back
' is pressed.
·
If '
Back
' is pressed, the Beltpack will stop searching and return to the
Registration
menu.
·
If '
Next
' is pressed, the current Net is blocked and the Beltpack will continue searching for other Nets. The blocking
list is cleared by reentering the
Registration
menu.
·
If '
Select
' is pressed, the user will be asked for the
OTA Registration PIN
that was defined via the Antennas Web-
Interface or via the Beltpack where the registration mode was enabled (by default the
Admin PIN
is used).
·
After registration, the Beltpacks are immediately connect to the Bolero net.
·
This setting is system wide and stays active until disabled or the registration timeout runs out.
·
The registration timeout is restarted each time a Beltpack is registered.
