2.Replacement and Adjustment
103
16.
Tighten the screws completely to secure the clincher side [A] of the stapler (
×3).
17.
Loosen the wing screw to remove the special tool.
18.
Reattach all the removed parts.
•
Make sure that the harnesses [B] are routed behind the resin part [A]. Otherwise, the
harnesses block the route of the stapler, which causes a Booklet Stapler Transfer Motor
(STM7) error.
19.
Check that the stapler works properly.
•
All staple patterns must be checked.
•
If there are any problems with the clincher, adjust the staple position with the special tool
again.
