Ricoh SP 230SFNw, Service Manual

Page: 117 / 255

2-96
Confidential
4.14.2Cannot update firmware
<User Check>
• Make sure that there is no other function running.
• Turn the power switch OFF and then back ON again.
* By the above update procedure, the other models firmware can be updated to the machine.
Check that the firmware is right and update correctly. If the other models firmware was
updated by mistake, the machine may repeat power ON/OFF or not powered ON. In such
case, replace the main PCB.
4.14.3“Paper Low” message does not disappear
<User Check>
• Turn the power switch OFF and then back ON again.
• Refill the paper in the appropriate paper tray.
Step Cause Remedy
1
Firmware version does not
match Reinstall the latest firmware.
2
In case of update failure by
interruption, the firmware
might not correctly written in
the ROM Update the firmware again by the following
procedure.*
1) Turn OFF the machine.
2) For with ten key models, press and hold
the [5] and turn the machine ON. For
without ten key models, press and hold
the [Option] and turn the machine ON.
3) Double-click the “Filedg32.exe” to start,
and select “Maintenance USB Printer”.
4) Drag and drop the firmware (upd file) in
the FILEDG32 screen. Update is started.
3 Main PCB failure Replace the main PCB ASSY.
Step Cause Remedy
1
Damaged plate-up plate in
the paper tray Replace the paper tray.
2 Paper feed motor failure Replace the paper feed motor.
3
Damaged plate push-up
mechanism in the machine Replace the frame L unit.
4 Main PCB failure Replace the main PCB ASSY.