Ricoh SP 1000S, Operating Instructions Manual

Page: 16 / 35

SP 1000S
- 13 -
2 - Installation
Feed cassette paper insertion
Your device accepts a number of formats and types of
papers.
1 Remove the paper feed cassette completely .
2 Push the lower panel down until it clicks.
3 Setup the back side feed cassette stop by pushing
the "PUSH" lever (
A ).
Then adjust the lateral paper guides to the paper
format by pushing lever (
B ) located on the left
guide. Adjust the length paper guide to the paper
format by pushing lever (
C ).
4 Take a paper stack, pull the paper off and align it
on a flat surface.
5 Put the paper stack in the feed cassette
(200 sheets for 80 g/m² paper for instance).
6 Put the feed cassette back in its location.
Cartridge installation
1 Stand in front of the machine.
2 Push the left and right sides of the cover and pull it
at the same time towards you.
3 Remove the starter toner cartridge from its bag.
Gently roll the cartridge 5 or 6 times to distribute the
toner evenly inside the cartridge.
Thoroughly rolling the cartridge will assure the
maximum copies per cartridge.
Hold it by its handle.
4 Insert the cartridge in its slot by pushing it until it
clicks (last move down) as shown on the picture
below.
5 Close the cover.
Important
See chapter Specifications for the
various formats and types of paper.
PUSH
B
A
C
8 7¼ 5½