Error ID
The error ID shown on the Service status display indicates the cause of the error.
Error
ID
Meaning
Cause
Solution
1
Lamp error
• Lifetime of the lamp has
ended.
• The rotation of the color
wheel is not detected.
• The lamp ballast is
defective.
• The temperature around
the lamp ballast is high.
• Replace the lamp.
• Clean the inside of the
projector.
• Replace the optics section.
• Replace the lamp ballast.
2
Lamp cover error
• The lamp cover is not
properly attached.
• The lamp cover open
sensor is defective.
• Check if the lamp cover is
properly attached.
• Check the lamp cover open
sensor.
3
Lamp off error
• The processor in the lamp
ballast is malfunctioning.
• The main processor is
malfunctioning.
Disconnect the power cord, and
then connect it again.
4
Fan 1 error
• Fan rotation speed is too
low.
• DAC error of the fan IC.
• Check if the fan connector
(CN5) is properly connected.
• Replace the intake fan.
• Replace the main board.
5
Fan 2 error
• Fan rotation speed is too
low.
• DAC error of the fan IC.
• Check if the fan connector
(CN7) is properly connected.
• Replace the exhaust fan.
• Replace the main board.
6
Fan 3 error
• Fan rotation speed is too
low.
• DAC error of the fan IC.
• Check if the fan connector
(CN8) is properly connected.
• Replace the lamp fan.
• Replace the main board.
5. Troubleshooting
72
Summary of Contents for Soleil-PJ WX4130
