Ricoh RW-480 PLOTCLIENT WIN, Software Manual

Page: 47 / 153

STAMP EDITOR
the button with the same name; i.e. "Save". This configura-
tion is now saved under the marked stamp name in the "Se-
lect Stamp " window.
4. You can produce as many stamps as you wish for a draw-
ing. If you now also want to configure an additional new
stamp, click on the following button:
5. Enter a name and set the desired configurations, as already
described under Step 3.
Stamp configurations
The stamp settings are usually saved for specific entries. This
means that these settings only apply for one entry or a limited
number of entries. However, you can also backup a stamp con-
figuration in its own "Stamp File". It can then be used at any time
for producing a new stamp, which you would like to use for o-
ther entries.
The stamp files have the file extension [*.stp] and it is advisable
that this extension is always retained.
Should you want to call up the configuration, you must use the
"Open" button. The "Open", "Save [as]" or overwrite old stamp
files steps are the same as those used in general file manage-
ment.
Edit or delete stamp
If you want to make changes to the stamp configurations pro-
duced, first click on the correct stamp in the "Select stamp " win-
dow and then change the settings. If you now change to
another stamp or close the window by clicking on "Ok", all the
settings are saved.
To delete a stamp, first mark it and then delete it by clicking on
the following button:
RW-480 CLIENTS 47