STAMP
EDITOR
Stamp editor
The stamp settings can be altered on two levels. To configure a
stamp for an individual entry, select the "Additional" tab under
"Entry". Now click on the "Settings" button under "Stamp". The
same button can be you in the "Defaults" area on the "Extended
Defaults " tab. The settings in the "Defaults" area are basic set-
tings, in which the following must always be noted:
Note
: Changes to the basic settings always only apply
to new entries that are added. Entries already included
in a job retain their settings.
In stamp editor you have two tabs in which you can alter set-
tings. These are the "Settings" and "Data" tabs. You can define
as many stamps as you like per drawing.
Make stamp
This chapter describes how you can name and save new
stamps.
Proceed as follows to configure a new stamp:
1. The first stamp entry is preliminarily named "000". Click on
the following symbol to edit the stamp name:
2. You can now delete the existing name entry and enter your
own name for the first stamp.
3. Now you can either enter your own settings for the stamps,
as described in the following chapters or use an existing
stamp configuration. To do the latter, click on the "Open"
button under "Configurations". Now select a configuration
that you have saved previously (read the following chapter
"Stamp Configurations") from the file selection. Now save
this configuration for the defaults or the entry by clicking on
RW-480 CLIENTS 46
Summary of Contents for RW-480 PLOTCLIENT WIN
