Using the Control Panel
42
5
Online Parameter Settings
No.
Mode
Description
1
Set aut-O/L def.
Sets Auto On Line to “ON” or “OFF” when the power has been
turned on, or when the mode has been cleared.
Note
❒
Default:
ON
2
Print Size def.
Sets the print size selected when the power has been turned on or
when the mode has been cleared.
Note
❒
Default:
Auto
3
List/Test Print
Prints the current set content of this machine.
Note
❒
Default:
System Print
5
IP Address
Sets the IP Address.
Note
❒
Default:
011.022.033.044
Reference
See
Printer Reference 1
for information about the IP Address
setting.
6
Ethernet Speed
Sets the Ethernet communication speed.
Note
❒
Default:
Auto
7
Network
Sets the Network boot.
Note
❒
Default:
None
Reference
See
Printer Reference 1
for information about the Network boot
setting.
8
I/O Timeout
Sets the time to enable the interface after data stops being re-
ceived. When the time set here is exceeded, it will be possible to
receive data from the other interface.
Important
❒
If the set time is too short, a time out might occur while one
data is being received. As a result, data from another interface
might cut in and be printed, or the emulation retrieval from
half of the data may be activated, and be replaced with a dif-
ferent emulation.
Note
❒
Default:
30 sec.
Summary of Contents for RCP40
