49
English
Appendices
Replacing the lamp
The projector automatically detects the lamp life. When the
lamp life is nearing the end of use, you will receive a warning
message.
Lamp is approaching the end of its useful life
Replacement suggested!
Warning! Lamp
When you see this message, please contact your local reseller
or service center to change the lamp as soon as possible.
Make sure the projector has been cooled down for at least 60
minutes before changing the lamp.
1
3
4
2
Lamp Replacement Procedure:
1. Switch off the projector power by pressing the “ ” button.
2. Allow the projector to cool down for at least 60 minutes.
3. Disconnect the power cord.
4. Unscrew the two screws on the cover.
1
5. Lift up and remove the cover.
2
6. Unscrew the two screws on the lamp module.
3
7. Pull up the lamp handle and remove the lamp module slowly and carefully.
4
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and use “Clear Lamp Hours” after the lamp module is
replaced.
The screws on the
lamp cover and the
lamp cannot be
removed.
The projector can-
not be turned on if
the lamp cover has
not been placed
back on the projec-
tor.
Do not touch the
glass area of the
lamp. Hand oil can
cause the lamp to
shatter. Use a dry
cloth to clean the
lamp module if it
was accidentally
touched.
