English
29
English
Basic Operations
Powering On the Projector
1. Ensure that the power cord and signal cable are securely
connected. The Power indicator will turn red.
2. Remove the lens cap (PJ X2240 / PJ WX2240).
3. Turn on the lamp by pressing
the
“ ”
button
on the control
panel or the remote control.
The Power indicator will
flash blue.
The startup screen will display in approximately 5 seconds.
After the screen disappears, the Power indicator will turn
blue.
4. The first time you use the projector, you will be asked
to select the preferred language. Turn on your source
(computer, notebook, video player, etc.) The projector will
detect your source automatically.
Make sure that the “Auto Source” has been set to “On”.
Powering On/Off the Projector
Turn on the
projector first and then
the signal sources.
Note
Lens Cap
Power
1
2
OR
CAUTION:
• Do not look into the lens while the lamp is on. The strong light from the
lamp may cause damage to your eyesight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to
internal overheating.
• Do not place your hands, face, or other objects near the air exhaust, the
lamp cover or the bottom of the unit. Doing so could result in injury and/or
damage the object.
If you connect
multiple sources at
the same time, press
“Input” to switch
inputs.
Note