7
121
Appendix
Error Messages
Error messages
Description
Memory card full
The memory card is full and no more
images can be saved. Insert a new
memory card or delete unwanted files.
No image
There are no images that can be played
back on the memory card.
This image cannot be
displayed
You are trying to play back an image
in a format not supported by this camera.
You may be able to play it back on
a computer.
No card in the camera
There is no memory card inserted
in the camera.
Memory card error
The memory card has a problem,
and image capture and playback are
impossible. You may be able to play
it back on a computer.
Card is not formatted
The memory card you have inserted is
unformatted or has been previously used
on another device and is not compatible
with this camera. Use the card after
formatting it with this camera.
Card is locked
The write-protect switch on the memory
card you have inserted is locked. (p.138)
This image cannot be
magnified
You are trying to magnify an image that
cannot be magnified.
This image is protected
You are trying to delete an image that is
protected. Remove the protection from
the image. (p.106)
Not enough battery power
remaining to activate Pixel
Mapping
These messages appear when you try
to perform Pixel Mapping or Sensor
Cleaning, or to update the firmware
if the battery level is insufficient.
Install a fully charged battery.
Not enough battery power
remaining to clean sensor
Not enough battery power
remaining to update the
firmware
Unable to update firmware.
There is a problem with the
firmware update file
Unable to update the firmware.
The update file is damaged.
Try downloading the update file again.
Image folder cannot be
created
The maximum folder number (999)
is being used, and no more images
can be saved. Insert a new memory
card or format the card.
Unable to store image
The image could not be saved because
of a memory card error.
The operation could not be
completed correctly
The camera was unable to adjust
the manual white balance.
Try the operation again.
No more images can be
selected
You are trying to select more than
the maximum number of images
for the following functions.
• Select & Delete
• RAW Development
• Protect
No image can be processed
There are no images that can be
processed using the Digital Filter
or RAW Development function.
This image cannot be
processed
Appears when you try to perform Resize,
Cropping, Digital Filter, Movie Edit, RAW
Development, or Save as Manual WB
for images captured with other cameras,
or when you try to perform Resize or
Cropping for minimum file size images.
Error messages
Description
KS2_OPM_EN.book Page 121 Friday, February 20, 2015 12:10 PM
