6
Settin
gs
100
4
Press
E
.
5
Press
F
.
The [E-Dial Programming] screen reappears.
Repeat Steps 2 to 5.
6
Press
F
twice.
t
Memo
•
If you select [Rotation Direction] in Step 2, you can reverse
the effect obtained by turning
Q
or
R
.
You can set whether to turn on the lights for the following
camera parts when
8
is pressed.
Set in [Illumination Settings] of the
D
2 menu. Selecting [Off] provides no
illumination even when
8
is
pressed.
You can set whether to light up the following indicator lamps on
the camera body.
Set in [Indicator Lamps] of the
D
2
menu.
For [Self-timer], the self-timer lamp
blinks during the countdown for the
drive mode [Self-timer (12 sec.)]. For
[Remote Control], the remote control
receiver lamp blinks during the
standby for shooting.
Setting the Lighting on the Camera Body
D
2
Specifying the Illumination Button Settings
LCD Panel
Off, Low, High
Backside Controls
Off, Low, High
Lens Mount
Off, On
Card Slot/Connector
Off, On
Setting the Illumination of the Indicator Lamps
Wi-Fi
Off, Low, High
GPS
Off, Low, High
Self-timer
Off, On
Remote Control
Off, On
Pressing the illumination button
Pressing the illumination button
will provide high illumination
will provide high illumination
for the LCD panel
for the LCD panel
Illumination Settings
Illumination Settings
LCD Panel
LCD Panel
Backside Controls
Backside Controls
Lens Mount
Lens Mount
Card Slot/Connector
Card Slot/Connector
Wi-Fi
Wi-Fi
GPS
GPS
Indicator Lamps
Indicator Lamps
Self-timer
Self-timer
Remote Control
Remote Control
K1-OPM-EN.book Page 100 Tuesday, March 22, 2016 5:05 PM