Ricoh Network Scanning Unit A, Operating Instructions Manual, Page: 186 / 206

Appendix
178
11
Configuring Wireless LAN
Settings
Preparation
Be sure to connect a scanner to this
machine before configuration, and
turn on the power of the scanner.
You cannot make any settings
without the connection.
It is necessary to change the net-
work settings of a client computer
that you use for configuring the
wireless LAN settings. Be sure to
note your computer’s network set-
tings before you change them, for
reference when you restore the set-
tings afterwards.
AAAA
Connect a client computer to this
machine.
When you use a cross network
cable
A
Connect a cross network cable
to the network interface con-
nector of this machine.
B
Connect the other end of the
cable to the client computer.
When you use a hub
A
Connect a straight network ca-
ble to the network interface
connector of this machine.
B
Connect the other end of the
cable to an available connector
of the hub.
C
Confirm that the computer is
connected to the hub
B
B B
B
.
If not connected, connect the
computer to the hub using a
1 0 B A S E - T o r 1 0 0 B A S E - T X
straight network cable.
BBBB
Change the computer's IP address
to 192.168.1.3, and subnet mask to
255.255.255.0.
CCCC
Restart the computer.
The computer's IP address is
changed to 192.168.1.3.
DDDD
Press the
{{{{
User Tools
}}}}
key on this
machine.
The scanner Features menu ap-
pears.
ZKJH060J
ZKJH060J
ZKJS020J