5. Horizontal line broken at 150 mm from center.
Possible causes:
• LPH subscan timing error at joint position
Other Problems
1. Excessive curl
Possible causes:
• When a paper roll reaches its end, the paper closest to the core tends to have excessive curl.
• There is no way to correct this. Operators should be instructed to use cut sheets if possible.
2. Shrinkage of areas in incomplete images
Possible causes:
• Some customers complained about loss of borderlines at the trailing edge of copies when an A1
original is reduced to A3.
• This problem has not been corrected.
Image Problem Troubleshooting
221
4
Summary of Contents for Neptune-P1
