Ricoh Mo-C1, Service Manual, Page: 573 / 1052

• If you do not want to print the list on paper, you can use SP5992 to write the list to an SD
card inserted in Slot 2.
3. Do SP5811-2 to display the serial number of the machine.
4. Write down the serial number of the machine. You will need to re-enter this number after initializing
the settings.
5. To initialize the SP settings, do SP5801-1.
• The total counter is not cleared when RAM is cleared.
6. Use SP5811 to re-enter the serial number of the machine.
NVRAM Data Upload/Download
Uploading NVRAM Data to an SD Card
Before you begin, please note:
• Uploading NVRAM contents to an SD card will fail if the machine serial number of the machine is
not registered with SP5811.
• The machine serial number is set at the factory before shipping.
• NVRAM data can be uploaded from several machines and stored on the same SD card because a
unique filename is created automatically for each machine.
1. Enter the SP mode and do SP5990-2 to print an SMC report.
• Always print an SMC report before uploading NVRAM data, just in case the download of the
NVRAM data fails.
• If the download fails, you can use the report to re-enter the SP and UP settings manually.
2. Turn the machine off.
3. Insert the SD card in Slot 2.
4. Turn the machine on.
5. Enter the SP mode and do SP5824 (NVRAM Data Upload).
6. Touch [EXECUTE] on the operation panel to start the upload.
• Data uploaded from NVRAM is stored in a file in the NVRAM folder created on the on the
card:
NVRAM folder> D1242702008.nv
where D1242702008.nv is the number of the machine entered at the factory before
shipping. The number will be unique for each machine.
System Maintenance Tasks
571