Ricoh Martini-C3.5, Operating Instructions Manual, Page: 63 / 90

Copy Paper
49
3
*8
The Extension unit (optional) is required to load B4 JIS or 8
1
/
2
"
×
14" size paper. (2,500
sheets can be loaded in this tray.)
*9
When loading paper, make sure the stack height does not exceed the lower limit
mark of the paper tray. The amount of paper that can be set is 10 mm/100 sheets ap-
proximately.
*10
It is recommended to place one sheet at a time.
*11
When using 3,000Sheet-100Sheet Staple Finisher, available custom size is 139.7-458
mm (5.5"-18.1").
*12
When loading translucent paper, set the paper direction according to the grain.
Note
❒
When loading paper in the paper trays 1-3, place the copy side face down.
❒
When loading paper in the bypass tray or the Large Capacity Tray (LCT),
place the copy side face down.
❒
When you use the bypass tray, it is recommended to set the copy paper direc-
tion to
L
.
❒
Do not use paper for inkjet printers.
❒
When you load OHP transparencies, check the front and back of the sheets,
and place them correctly, or a misfeed might occur. Set the paper direction to
L
. For details, see Copy/Document Server Reference.
❒
When you use OHP transparencies, fan them for each use.
❒
If multiple sheet feeding occurs, load sheets one by one.
❒
When you load label paper, set the paper direction to K .
❒
If you load paper of the same size in the same direction in two or more trays,
the machine automatically shifts to the other tray when the first tray in use
runs out of paper. This function is called Auto Tray Switching. (However, if
the Paper Type of one tray is recycled or special paper, the settings of the oth-
er trays must be the same for the Auto Tray Switching function to work.) This
saves interrupting a copy run to replenish paper when making a large
number of copies. See “General Features” and “Tray Paper Settings”, General
Settings Guide.
❒
If you want to use paper of thicker than 90 g/m
2
, select
[
Thick Paper
]
in paper
type setting (80 ppm models).
ZGJS870E