Ricoh LP124w, Software Manual

Page: 253 / 376

Remote Maintenance by telnet
239
6
• If Secured Sockets Layer (SSL, an encryption protocol) function is not
available for the printer, you cannot use the function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}
msh> set rfu6 {up | down}
msh> set ipp {up | down}
msh> set ipp6 {up | down}
msh> set http {up | down}
msh> set http6 {up | down}
msh> set bonjour {up | down}
msh> set ssh {up | down}
msh> set ssdp {up | down}
msh> set nbt {up | down}
msh> set sftp {up | down}
msh> set sftp6 {up | down}
show
Use the “show” command to display network interface board configuration set-
tings.
❖
View settings
msh> show
• If “-p” is added, you can view settings one by one.
Reference
p.258 “Understanding the Displayed Information”.
slp
Use “slp” command to view and configure SLP settings.
msh> slp ttl "ttl_val"
• You can search the NetWare server using SLP in the PureIP environment of
NetWare 5/5.1 and Netware 6/6.5. Using the “slp” command, you can con-
figure the value of TTL which can be used by SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local seg-
ment. If the router does not support multicast, the settings are not available
even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.