Ricoh LD520CL, Operating Instructions Manual

Page: 485 / 956

Program Special Sender
Program/Change/Delete Special Senders, perform initial setup, and print the Special Sender List.
You can set functions for each sender if Special Senders are preprogrammed. For details, see
“Program Special Sender”.
Program Memory Lock ID
Program a Memory Lock ID to be entered before printing documents when the Memory Lock function
is activated.
Preprogram the ID when you set “Memory Lock” and “Program Special Sender”-“Memory Lock”.
1. Select [Fax Features] using [ ] or [ ], and then press the [OK] key.
2. Select [Administrator Tools] using [ ] or [ ], and then press the [OK] key.
3. Select [Program Memory Lock ID] using [ ] or [ ], and then press the [OK] key.
4. Enter the ID using the number key, and then press the [OK] key.
A Memory Lock ID can be any four-digit number, except 0000.
If you make a mistake, press the [Clear/Stop] key before pressing the [OK] key, and then enter
again.
5. Press the [User Tools/Counter] key.
For details about printing a file received with Memory Lock, see “Printing a File Received with Memory
Lock”.
Select Dial/Push Phone
Use this function to select a line type.
Dial and Push lines are available for selection.
This function is not available in some areas.
1. Select [Fax Features] using [ ] or [ ], and then press the [OK] key.
2. Select [Administrator Tools] using [ ] or [ ], and then press the [OK] key.
3. Select [Select Dial/Push Phone] using [ ] or [ ], and then press the [OK] key.
4. Select [Push Phone] or [Dial Phone (10PPS)] using [ ] or [ ], and then press the [OK] key.
5. Press the [User Tools/Counter] key.
G3 Analog Line
You need to make the following settings for the G3 Analog Line before you connect the machine to
a standard G3 analog line.
• When your machine is connected through a PABX, set to Extension. If it is connected directly to
the telephone network, set to Outside.
The default setting is Outside.
• Outside Access No.
Administrator Tools
155
6