Ricoh LD520CL, Operating Instructions Manual

Page: 423 / 956

• p.151 "General Settings/Adjust"
• p.193 "Maximum Values"
Entering a Password
There are times you may want to use a password when receiving faxes by SEP Code Reception.
• For the maximum number of digits for the PWD Code, see “Maximum Values”.
• You can enter numbers, , , and spaces.
• You can store PWD Codes as well as names and fax numbers in the destination list. For registering
into the destination list, see “Registering Addresses and Users for Facsimile Functions”, Network and
System Settings Guide.
• The PWD Code is printed on lists and reports.
• p.193 "Maximum Values"
SEP Code RX Reserve Report
This report is printed after SEP Code Reception is set up.
You can use this report to check the reservations for SEP Code Reception.
• You can turn this function on or off with the User Parameter (switch 03, bit 3) in the Fax Features menu.
• If user authentication is set, you can select whether to display a destination with the User Parameter
(switch 04, bit 4) in the Fax Features menu.
• If user authentication is set, you can select whether to display a sender name with the User Parameter
(switch 04, bit 5) in the Fax Features menu.
• For details about Parameter Setting, see “Parameter Settings”.
• p.166 "Parameter Settings"
SEP Code RX Result Report
This report is printed after each SEP Code Reception is completed and shows its result.
Setting SEP Codes for Reception
93
2