Ricoh ISC 2525, Operating Instructions Manual, Page: 56 / 206

Copying
34
2
Copying from the Bypass Tray
Use the bypass tray to copy onto OHP transparencies, adhesive labels, translu-
cent paper, postcards and copy paper that cannot be loaded in the paper trays.
Important
❒
When the duplex unit is attached, the default is [ 1 Sided
→
2 Sided ] . When cop-
ying from the bypass tray, select
[ 1 Sided ]
for copying in
[ Dup./Combine/Series ]
(for example [ 1 Sided
→
1 Sided ] or [ 2 Sided
→
1 Sided ] ). You can change the in-
itial settings. See “Programming Defaults in Initial Display”.
❒
Paper has a vertical length of 90-305 mm (3.6-12 inch) and a horizontal length
of 148-457.2 mm (5.9-18 inch) can be copied from the bypass tray.
❒
The machine can detect the following sizes as regular size copy paper: A3
L
,
A4 L , 8”
×
13” L . If you want to use the size of paper other than the above, be
sure to specify the size.
❒
When copying on OHP transparencies or paper heavier than 128 g/m
2
(about
90 kg, 34 lb.), you need to specify the type and size of paper with “Special
Original”.
❒
The maximum number of sheets you can load at the same time depends on
paper type. The maximum number of sheets should not exceed the upper lim-
it.
❒
When copying paper lighter than 59g/m
2
or tracing paper, you need to spec-
ify the paper type.
❒
When paper larger than 433 mm (17.1 inch) in size is used, the paper may be-
come wrinkled, may not be fed into the machine, or may cause paper jams.
❖
[ Bypass Tray Usage ] key
Press
[ Bypass Tray Usage ]
to display a description on using the bypass tray.