4
4-19
Network Setup options
Enable Auto IP Configuration
Yes/No [Yes]
Select Yes to allow the E-820 to obtain its Ethernet IP address by searching the
network. Depending on your network and the protocol you select in the following
option (DHCP, BOOTP, or RARP), the IP address can change. Select No to assign the
E-820 a static IP address. If you select No, you proceed to the IP Address option,
where you manually set the IP address.
Select protocol
DHCP/BOOTP/RARP [DHCP]
This option appears only if you answered Yes to Enable Auto IP Configuration. Select
the protocol over which the E-820 should search for its IP address. Both DHCP and
BOOTP allow the E-820 to obtain the Ethernet IP address and Subnet Mask
automatically. RARP obtains only the Ethernet IP address.
Depending on your network, the E-820 might be assigned a different address after you
restart the E-820. With the DHCP setting, the E-820 can be assigned a different
address even if it is not restarted. Make sure the network is already configured properly
for the protocol you select.
Get Gateway Address Automatically
Yes/No [Yes]
Use this option to assign the gateway address automatically for printing with TCP/IP.
This option appears only if you selected DHCP or BOOTP as the protocol in the
previous option.
If you select a DHCP or BOOTP protocol and later change it to RARP, you must
return to Setup and set this option to No. You can then set the address manually.
RARP does not support automatic assignment of the gateway address.
IP Address
[127.0.0.1]
Enter the E-820 IP address for Ethernet. This IP address, unlike an IP address set
automatically, remains the same if you restart the E-820. You must change the default
to a valid address for your network. For information about setting up printing with
TCP/IP, see
