5
5-1
Accessing Setup
After you perform initial Setup (Server, Network, and Printer Setup) from the Control
Panel, you can change most Setup options from a Windows computer.
Accessing Setup
In addition to using the Control Panel, you can set up the E-820 two ways: locally
and remotely. Local Setup is for systems with the Fiery Advanced Controller
Interface. Local Setup uses a Windows NT application, Fiery Server Setup.
Remote Setup is performed from a Windows computer using WebSetup or Command
WorkStation.
N
OTE
:
In this chapter, illustrations for both Setup interfaces, where applicable, appear
side by side: local Setup on the left, remote Setup on the right. Descriptions for the
Setup options are listed in the order in which they appear on the local Setup window.
Some Setup options cannot be accessed from remote Setup; use local Setup or the
E-820 Control Panel instead.
Regardless of how you access Setup, you must log in as Administrator, both at the
E-820 and within the Setup application you use. After the E-820 restarts, log in to the
Windows NT Logon window with the Administrator as the login name and enter the
password, if required.
N
OTE
:
The default Windows NT password is “Fiery.1”. You are always prompted to
enter this password unless you have set a new password.
To use the Setup applications (WebSetup or Command WorkStation), you must enter
the E-820 Administrator password. This is set either from the local Setup at the
Control Panel, or remote Setup from WebSetup or Command WorkStation.
Chapter 5:
Setting up
the E-820 from
a Windows
Computer
