Ricoh DDP70, Maintenance Manual

Page: 92 / 137

Disassembling, Assembling & Adjustment
6-17
M M L 0 0
6.5.3. Removal of the Up-down Stay
Applicable jigs and tools:
⊕
Screwdriver.
[Disassembling Procedures]
1. Remove the Rear Cover. (Refer to item 6.1.1 on page 6-1)
2. Remove the Front Side Cover. (Refer to item 6.1.3 on page 6-3)
3. Remove the Shift Tray. (Refer to item 6.5.1 on page 6-14)
4. Remove the Paper Exit Stopper Plate. (Refer to item 6.5.2 on page 6-15)
5. Unscrew the four
⊕
screws of the Cable Bracket to remove the Up-down Stay.
Figure 6-27. Removal of the Up-down Stay
[Assembling Procedures]
1. Reinstall the Up-down Stay by reversing the procedure above, paying attention to
the following caution.
Figure 6-28. Removal of the Up-down Stay
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.
CAUTION:
When the Up-down Stay is pressed down, the four
⊕
screws of the Cable Bracket Up-
down Stay will tighten.
⊕
SCREWS
CABLE BRACKET (FRONT) UP-DOWN STAY
CABLE BRACKET
(REAR)
⊕
SCREWS
PUSH DOWNWARDS
⊕
SCREWS
UP-DOWN STAY
⊕
SCREWS