Ricoh DDP70, Maintenance Manual

Page: 111 / 137

6-36
DDP70 Finisher Maintenance Manual M M L 0 0
6.7.6. Adjusting the Paper Exit Opening Solenoid
Applicable jigs and tools:
⊕
Screwdriver.
[Disassembling Procedures]
1. Remove the Rear Cover and the Top Cover. (Refer to item 6.1.1 on page 6-1)
[Adjustment Procedures]
1. When the Paper Exit Opening Solenoid (SD4) is ON, check that the gap between
the Solenoid Plunger and the Bracket Stopper is the value stated below:
Value: A = 6.0 ± 0.5 mm.
Figure 6-61. Adjustment of the Paper Exit Opening Solenoid
2. Remove the two Solenoid Bracket
⊕
screws and remove the Solenoid together
with the Bracket.
Figure 6-62. Adjustment of the Paper Exit Opening Solenoid
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.
SD4
A = 6.0±0.5 mm
BRACKET/SOLENOID
⊕
SCREWS