Ricoh D127, Field Service Manual

Page: 152 / 474

32
Data incorrect after download
interrupted
Execute the recovery procedure for the intended
module download, then repeat the installation
procedure.
33 Incorrect SD card version
Incorrect ROM data on the SD card, or data is
corrupted.
34
Module mismatch - Correct
module is not on the SD card) SD update data is incorrect. Acquire the correct data
(Japan, Overseas, OEM, etc.) then install again.
35
Module mismatch - Module on
SD card is not for this machine
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
36
Cannot write module - Cause
other than E34, E35
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
40 Engine module download failed
Replace the update data for the module on the SD card
and try again, or replace the BICU board.
42
Operation panel module
download failed Replace the update data for the module on the SD card
and try again, or replace the LCDC.
43
Stamp data module download
failed Replace the update data for the module on the SD card
and try again, or replace the hard disks.
44
Controller module download
failed Replace the update data for the module on the SD card
and tray again, or replace controller board.
50
Electronic confirmation check
failed
SD update data is incorrect. The data on the SD card is
for another machine. Acquire correct update data then
install again.
Test Pattern Print (SP2-109-001)
Executing Test Pattern Printing
1. Touch the item you want to activate then the item "OK" displayed on the touch panel.
2. Press the key. The copy mode is activated.
3. Specify copy settings and press the key.
4. To return to the SP mode, Touch the item "To SP" displayed on the upper left corner on the touch
panel.
5. System Maintenance Reference
150