Ricoh D127, Field Service Manual

Page: 144 / 474

Starting SP Mode
For details, ask your supervisor.
Selecting Programs
• When you want to jump to the program directly, confirm the item "SP Direct" [A] selected and put
the SP number you want to operate by the keypad. Then press the "#" key [B].
• When you want to select the program in the menu, touch the signs [C] to scroll through the menu.
Then touch the item you want to operate.
Specifying Values
1. After locating a program, type the keypad to put the number in as the value. To switch between
positive (plus) and negative (minus) values, press the key.
2. Press the "#" key [B] to confirm the value or the "C" key [D] to cancel.
Activating Copy Mode
You can activate the copy mode while the SP mode is running. When you do so, the copier outputs
images or patterns that help you adjust the SP setting.
1. Press the key [E]. The copy mode is activated.
2. Specify copy settings and press the key [E].
3. To return to the SP mode, touch the item "To SP" displayed on the upper left corner on the panel.
• You cannot end the SP mode while the copy mode is activated.
Quitting Programs/Ending (S) SP Mode
Touch the item "Exit" displayed on the upper right corner on the panel to quit the program or end the SP
mode.
Conventions used in the tables:
• Asterisk (*): The settings are saved in the NVRAM. Most of them return to the default values when
you execute SP5-801-002. CTL indicates that the data is contained in NVRAM on the controller
board.
• DFU: The program is for design/factory use only. Do not change the settings.
5. System Maintenance Reference
142