Ricoh C249, Service Manual

Page: 470 / 486

NIB
C624 18 SM
2.2 NIB

CAUTION
Before removing any of the controller components, do the following:
1. If the ‘data-in’ lamp on the operation panel is blinking or lit, wait until a
document or report is printed. Then turn off the machine.
2. Turn off the main switch and disconnect the power cord and the cable.
NOTE: 1) Before replacing the NIB, print the configuration page.
[User Tools] – [6 Online Paramet's] – [3 List/Test Print] – [System Print].
(For model #C249)
[User Tools] – [7 Set O/L Paramet's] – [3 List/Test Print] – [System
Print]. (For models #C239/C244)
Then, replace the NIB. Then input the network settings using the User
Tools, SmartDeviceMonitor for Admin, and Web Status Monitor.
2) If you replace the NIB with a NIB from another machine, access SP9-
32 (NIB NVRAM) (For model #C249)/ SP9-2-3 (NIB NVRAM) (For
models #C239/C244) to initialize all the data (machine information) in
the NIB NVRAM.
1. Print the configuration page using
[User Tools] – [6 Online Paramet's] – [3 List/Test Print] – [System Print].
(For model #C249)
[User Tools] – [7 Set O/L Paramet's] – [3 List/Test Print] – [System Print].
(For models #C239/C244)
2. Remove the controller cover (
!
2.1).
3. Replace the NIB (

x 2).
4. Turn on the machine and input the network settings using the utilities.
5. Turn off the machine and then turn it back on. Then, print the configuration
page.
[User Tools] – [6 Online Paramet's] – [3 List/Test Print] – [System Print].
(For model #C249)
[User Tools] – [7 Set O/L Paramet's] – [3 List/Test Print] – [System Print].
(For models #C239/C244)
Make sure that all the controller settings are correct.