Ricoh BE-C1 D046, Field Service Manual, Page: 529 / 734

8. Appendix: SP Mode Tables
SP Table Key
Notation What it means
[range/step]
Example: [-9 to +9/0.1 mm]. Setting can be adjusted in the range
±
9, and
the value can be changed in 0.1 mms with each key press. The initial settings
are recorded in the SMC report and displayed on the operation panel in
the "Initial" box of each SP setting display.
italics Comments.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only Feature or item is for Japan only. Do not change this value.
GW These SP codes are related to controller operation.
• As a general rule, cycle the machine off and on with the main power switch every time you enter
numbers for a new SP code settings. Switching the machine off and on enables the new settings.
• After you reset any SP code in Groups 1000 to 4000, a message on the operation panel will prompt
you to cycle the machine off and on.
• The machine must be cycled off and on after changing any SP code in Group 5000 as well. However,
a message does not appear to prompt you to cycle the machine off and on.
• Never turn off the main power switch when the power LED is lit or flashing. To avoid damaging the
hard disk or memory, press the operation power switch on the operation panel to turn the power off,
wait for the power LED to go off, then turn the main power switch off.
81
8